ABSTRACT
OBJECTIVE: To analyze the occupational hazard factors and their critical control points in the process of construction of a large-scale construction project.METHODS: The engineering analysis, worksite survey occupational health and occupational hazard factor testing were conducted in a large-scale construction project, and the results were analyzed. RESULTS: During the process of construction of this large-scale construction project, there were many occupational hazard factors such as silicon dust, welding smoke, wood and other dusts, inorganic compounds of manganese, carbon monoxide, carbon dioxide, nitric oxide, ozone, noise, high temperature, hand-transmitted vibration and ultraviolet irradiation, among them, silicon dust and noise were the most common ones. The over standard rates of exposure concentration of short term of total dust and respirable dust in the workplace were 68.2%(15/22) and 40.9%(9/22), and the over standard rates of exposure concentration of time weighted average were 54.5%(12/22) and 13.6%(3/22), respectively. The over standard rates of the noise intensity of area sampling and personal sampling in workplace were 69.2%(45/65) and 61.0%(25/41) respectively. The four hours energy equivalent frequency-weighted acceleration to vibration of three hand-transmitted vibration positions has been detected, and the result has surpassed the occupational exposure limit.The results of other occupational hazard factors such as high temperature, ultraviolet radiation, wood dust, welding smoke, other dust, manganese inorganic compounds, carbon monoxide, carbon dioxide, nitric oxide, nitrogen dioxide, hydrogen sulfide, hydrogen cyanide and ozone all met the occupational exposure limits. CONCLUSION: There are various occupational hazard factors in the process of construction of this large-scale construction project, among them, noise, dust and hand-transmitted vibration are the most prominent hazards.These hazards are the critical control points of this type of construction projects.
ABSTRACT
OBJECTIVE: To establish a method for testing tetrahydrofuran( THF) in workplace air by solvent desorption gas chromatography. METHODS: The air samples were collected by activated carbon tube,desorbed with carbon disulfide solution,then separated by capillary column and detected by flame ionization detector. RESULTS: The linearity range of THF concentration was 1. 78-8 892. 00 mg / L,and the correlation coefficient was 0. 999 9. The minimum detection limit of THF was 0. 09 mg / m3. The minimum quantitative concentration was 0. 27 mg / m3( 3. 00 L air collection). The average desorption efficiency of THF was 94. 29%-96. 46% when placed overnight at the room temperature. The within-run and the between-run relative standard deviation were 0. 30%-0. 91% and 0. 66%-1. 23% respectively. THF sample could be stored at room temperature for at least 8 days. CONCLUSION: The method could be widely applied in sampling and detection of THF in workplace air.